Bailey Smoke & Carbon Monoxide Alarms (2019 Model Year, Advance / Alliance / Autograph)
Sourced from Bailey's 2019 model year owner's manual for the Advance / Alliance / Autograph motorhome range. If your motorhome is a different age or range, some details - such as the exact control panel brand or chassis-component generation actually fitted - may not match. Always cross-check against the handbook that came with your specific motorhome.
View official manual on manufacturer's site ↗Parts & Appliances Fitted
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|
N/A | Smoke alarm does not sound when the test button is pressed, or the operating light does not flash every 40 seconds Possible Cause: Obvious damage, wrong or disconnected battery, or a dirty/blocked sensor. | Inspect for obvious damage, check the unit contains the recommended battery type, check the battery cover has been removed and the battery is properly connected, and gently vacuum the unit with a soft brush attachment. Replace the battery. If these steps do not correct the problem, do NOT attempt repairs — replace the smoke alarm. | DIY Safe |
N/A | CO alarm emits an audible 'chirp' once a minute Possible Cause: A fault with the battery, sensor, or circuitry, including a low battery. | Replace the battery to ensure occupant safety. If the device continues to chirp despite new batteries and is still under warranty, contact technical support; if out of warranty, replace the detector immediately. | DIY Check / Tech Fallback |
N/A | CO alarm sounds (loud audible signal, alarm LED flashing red once a second) Possible Cause: Carbon monoxide detected in the motorhome. | Keep calm, open all doors and windows to ventilate. Stop using and turn off all fuel-burning appliances. Evacuate the motorhome, leaving doors and windows open, and do not re-enter until the alarm has stopped. Get medical help for anyone suffering effects of CO poisoning. Do not use the motorhome again until it has had a full service of all appliances by your supplying retailer — gas appliances must be tested by a GAS SAFE registered installer. | Professional Intervention Required |