Covers: Pegasus, Unicorn
Unicorn models: Seville, Madrid, Valencia, Cadiz, Barcelona, Cartagena
Pegasus models: Genoa, Verona, Rimini, Ancona, Bologna, Turin
Bailey Digital TV Antenna System
(2013 Model Year, Unicorn / Pegasus)
Sourced from Bailey's 2013 model year owner's manual for the Unicorn / Pegasus range. If your caravan is a different age or range, some details — such as the exact control panel brand or chassis-component generation actually fitted — may not match. Always cross-check against the handbook that came with your specific caravan.
View official manual on manufacturer's site ↗Also Fitted To This Caravan
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Possible Cause | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|---|
N/A | TV/radio picture or reception problem (Status 550 antenna) | A coaxial connection in the system is not fitted correctly. | Make sure every coaxial connection in the system is properly seated. | DIY Safe |
N/A | TV picture is affected by a strong signal near a transmitter (Status 550 antenna) | Gain Control has been turned fully clockwise (maximum) somewhere the signal is already strong. | Rotate the Gain Control button anti-clockwise (through up to 270 degrees) until picture quality improves. | DIY Safe |
N/A | The LED on the Amplifier does not light (Status 550 antenna) | No power to the unit, or incorrect polarity. | Start by confirming the unit is getting power, then verify the polarity. If it's still not lit after that, Grade UK Ltd can help further. | DIY Check / Tech Fallback |
N/A | Unclear whether a poor TV signal is caused by the Amplifier/wiring or the antenna itself (Status 550 antenna) | — | Two isolation tests can narrow this down. Test 1: disconnect the coaxial plugs from the Amplifier's 'TV' sockets, then wire the TV straight to the Amplifier using the TV fly lead and Converter 1 (Antenna Dome still plugged into 'ANT-IN'). A better picture here points to the wiring between the Amplifier and the TV outlet as the culprit.
Test 2: disconnect the Antenna from the Amplifier, fit Converter 2 onto the cable end, and link the antenna straight to the TV with the fly lead. A better picture this time means the Amplifier unit itself is at fault. | DIY Safe |