Bailey • Approach Autograph • 740 • 2013

10479 FAQs5 Types
Official manual on Bailey's site:View PDF ↗
Caprice

Gas Hob/Cooker (as fitted to Bailey caravans and motorhomes, 2013-2015)

Hob / Cooker
2000 FAQs
View full Caprice page →

Master Troubleshooting & Diagnostics Matrix

Error Code / IndicatorSymptom / MeaningPossible CauseStep-by-Step DIY FixSuggested Actions
N/A
A hob burner flame accidentally extinguishes
Each burner is monitored individually by a thermocouple probe as part of its flame-supervision safety system.Turn off the burner control and do not attempt to re-ignite the burner for at least one minute.DIY Safe
N/A
A hob burner has not lit within 15 seconds of ignition
—Release the control knob and leave the burner for at least 1 minute before a further attempt to ignite it.DIY Safe
Bailey

230V/12V Electrical System & Control Panels (2013 Model Year, Approach)

Electrical
1010 FAQs
View official manual on manufacturer's site ↗

Master Troubleshooting & Diagnostics Matrix

Error Code / IndicatorSymptom / MeaningPossible CauseStep-by-Step DIY FixSuggested Actions
N/A
A miniature circuit breaker (MCB) on the mains unit has tripped to the OFF position
A fault has developed in the 230V circuit protected by that MCB, or too many appliances are drawing power at once.Sort out the fault first (or cut back the load), then re-set by pushing the MCB upward, against its spring, back to the ON position.DIY Safe
N/A
The RCD (residual current device) does not switch off when the test button marked 'T' is pressed
The RCD unit itself is faulty.The mains supply system must not be used - get a qualified electrician in.Professional Intervention Required
Bailey

Gas Supply System (2013 Model Year, Approach)

Gas Regulator / Supply
0010 FAQs
View official manual on manufacturer's site ↗

Master Troubleshooting & Diagnostics Matrix

Error Code / IndicatorSymptom / MeaningPossible CauseStep-by-Step DIY FixSuggested Actions
N/A
Smell of gas / suspected gas leak
—Shut the gas off at the cylinder right away. Put out naked flames, cigarettes and pipes. Leave every electrical switch and appliance untouched. Open every door and window so the escaping gas can clear. If you can't pin down the leak, everybody should leave the motorhome while you call a competent service engineer - never hunt for a leak with an open flame; a soapy solution or a dedicated spray does that job instead.Professional Intervention Required
Dometic

RM8xxx / RMS8xxx / RML8xxx / RMSL8xxx 8 Series Absorption Refrigerator

Fridge / Freezer
6349 FAQs
View full Dometic page →

Technical Specifications

ElectricalMains 230V AC, On-board battery 12V DC, Heating element ratings 125W to 190W depending on model
Gas Or PressureLiquid gas (Propane/Butane). Operating pressure: 30 mbar (50 mbar requires Truma VDR 50/30 medium pressure controller). Gas ignition limits up to approx. 3280 ft / 1000 m altitude.
Capacities DimensionsGross capacities range from 80 liters to 189 liters depending on model. Net weights range from 25 kg to 45 kg.

Master Troubleshooting & Diagnostics Matrix

Error Code / IndicatorSymptom / MeaningPossible CauseStep-by-Step DIY FixSuggested Actions
N/A
Refrigerator does not cool sufficiently
Inadequate ventilation, thermostat setting too low, heavily frosted condenser, or warm food stored recentlyCheck the ventilation grilles aren't covered, turn the thermostat up, confirm the door's closing properly, and let warm food cool before storing it.DIY Safe
N/A
The fridge isn't cooling in gas mode
Gas cylinder empty, upstream shut-off device closed, or air in the gas pipeSwap the gas cylinder, open the shut-off device, and switch the appliance off and restart it 3-4 times to clear any trapped air.DIY Safe
N/A
The fridge isn't cooling in 12V mode
Could be a blown onboard fuse, a flat onboard battery, the engine not running, or a faulty heating element.Fit new fuse, check/charge battery, start engine, or contact Dometic Customer ServiceDIY Check / Tech Fallback
N/A
The fridge isn't cooling in 230V mode
Could be a blown onboard fuse, the vehicle not being connected to mains, or a faulty 230V heating element.Fit new fuse, connect to mains power supply, or contact Dometic Customer ServiceDIY Check / Tech Fallback
N/A
MES/AES failure: 230V mode LED flashing + acoustic signal
Either no 230V supply is reaching the unit, or the voltage is too low.Check the mains connection, mains voltage, and fuse.DIY Safe
N/A
MES/AES failure: 12V mode LED flashing + acoustic signal
12V not available, voltage too low, or D+ signal missingCheck 12V connection, on-board battery, fuse, and D+ signal (AES)DIY Safe
N/A
MES/AES failure: Gas/Automatic mode flame not ignited
Flame not ignited, gas supply interrupted, burner/nozzle defectiveCheck gas supply (bottle, valve), clean burner/nozzle, and press the fault reset button after clearingDIY Safe
N/A
All temperature setting LEDs are flashing (both MES and AES panel styles)
Temperature sensor defectiveThe refrigerator will continue to work on the mid temperature setting. Contact Dometic Customer Services to have the temperature sensor checked/replaced.Professional Intervention Required
N/A
"HE1" is flashing (LED plus all temperature setting LEDs flashing)
230V heating element defectiveContact Dometic Customer Services - the 230V heating element requires replacement.Professional Intervention Required
N/A
"HE2" is flashing (LED plus all temperature setting LEDs flashing)
12V heating element defectiveContact Dometic Customer Services - the 12V heating element requires replacement.Professional Intervention Required
N/A
Reduced cooling performance in high ambient temperatures
The refrigerator is struggling to keep up in hot conditions - normal behaviour at the margins of its rated operating range, not necessarily a fault.Check ventilation isn't restricted, park in shade where possible, and set a lower cooling level in hot weather.DIY Safe
N/A
Exhaust fumes or unburnt gas entering the vehicle's living space
A fault in the gas combustion or flue/exhaust system.Stop using the refrigerator on gas immediately and have it checked by an authorised Dometic service agent before using gas mode again.Professional Intervention Required
N/A
The vehicle's battery discharges quickly while stationary
The refrigerator drawing more 12V current than expected while parked, possibly indicating a fault.Check whether the refrigerator is the cause by monitoring battery drain with it switched off; if it's responsible, have it checked by an authorised Dometic service agent.DIY Check / Tech Fallback

Frequently Asked Questions

Q: What does the SN climate class on my Dometic RM fridge mean?

Climate class SN (which Dometic calls 'Extended Temperate') means the fridge is designed to work reliably when the air temperature is from +10°C up to +32°C (taken at the bottom vent grille, outside the vehicle).

Q: How well does an absorption fridge cool in hot weather?

In a hot summer the outside temperature often reaches about 32°C - the top of the fridge's rated range - and once it climbs higher, the temperature inside the fridge will inevitably rise. An absorption fridge needs a heat source to move its refrigerant around the cooling unit (which is why it can run on 12V, 230V or gas), so it has to get rid of the heat from its power source as well as the heat drawn out of the food compartment.

To help it in hot weather: park where the fridge vents get as much shade as possible during the day; unclip the outside vent grilles to improve airflow; and if you regularly travel somewhere hot, consider having a ventilator kit (a fan fitted behind the fridge) installed to boost the airflow - Dometic lists these among its accessories.

Q: Can my Dometic RM8 fridge run from solar power?

The RM(X)8xxx range can take an S+ signal on its control board, which lets it pick solar-supplied DC power when it's available. For this you need a solar regulator from Dometic's Büttner range that has a signal output cable, wired to S+. The panel charges the leisure battery (or batteries), and whenever the regulator signals that solar power is available, the fridge gives it top priority in AES (automatic) mode.

In automatic mode the fridge chooses its energy source in this order: solar DC first, then mains AC, then ordinary 12V DC, and gas last. Most AES set-ups take their 12V feed from the vehicle's starter battery, with the alternator's D+ signal allowing DC operation; to use the S+ signal instead, you'll need a changeover switch so the 12V heating element is supplied from the leisure battery rather than the vehicle battery.

On 12V the element is rated 120-190W, so the fridge draws a continuous 10-15A on DC - more than most vehicles' leisure batteries can sustain for long, which is why this solar/DC mode tends to be used where the fridge is fitted in a beach hut or similar off-grid building. Bear in mind that changing the vehicle's wiring could void your warranty - Dometic advises checking with your dealer first.

Q: What can replace my old Dometic RM fridge?

Dometic's 2023 'New for old - simply swap' guide covers both its absorption and compressor fridges, showing which current models replace older ones. It's available from the catalogues section of Dometic's website.

Q: My fridge won't work on mains (AC) power - what should I check?

Check the fuse in the mains supply and replace it if it has blown, and make sure the vehicle is actually plugged into a mains supply. If both are fine, the AC heating element may have failed - that needs an authorised Dometic service centre.

Q: My fridge won't work on 12V (DC) - what should I check?

Possible causes, and what to do: the vehicle's own fuse has blown - replace it (see the vehicle's handbook); the vehicle battery is flat - test it and recharge it; the ignition is off - switch it on. If the fuse in the fridge's DC cable has blown (the fuse on the relay) or the DC heating element has failed, contact an authorised Dometic service centre.

Q: My fridge won't work on gas - what should I check?

Check the gas cylinder isn't empty (change it if it is) and that the gas valve is turned on. If air has got into the gas pipe, turn the fridge off and on again, repeating this three or four times if needed; if a gas hob or cooker is fitted, switch that on, then try the fridge again if needed.

Q: Why is my fridge running on gas in automatic mode when I'm plugged into mains?

The mains voltage is too low. The fridge switches back to mains by itself once the supply voltage recovers.

Q: Why isn't my fridge getting cold enough?

Work through the likely causes: the cooling unit isn't getting enough air - make sure the outside vent grilles aren't blocked; the evaporator has iced up - check the door shuts properly and the seal is seated and undamaged, then defrost the fridge; the temperature setting is too warm - turn it to a colder setting; it's very hot outside - take the vent grille off for a while so hot air can escape faster; too much food, or too much warm food, went in at once - take some out, and let warm food cool before putting it back; the fridge was only switched on recently - give it four to five hours, then recheck the temperature.

Bailey

Smoke & Carbon Monoxide Alarms (2013 Model Year, Approach)

Smoke / CO Alarm
1110 FAQs
View official manual on manufacturer's site ↗

Master Troubleshooting & Diagnostics Matrix

Error Code / IndicatorSymptom / MeaningPossible CauseStep-by-Step DIY FixSuggested Actions
N/A
The smoke alarm stays silent when you press its test button, or its status light isn't blinking on its usual 40-second cycle
Obvious damage, wrong or disconnected battery, or a dirty/blocked sensor.Look the unit over for visible damage, confirm the right battery type is fitted with the cover off and the connection secure, and give it a gentle vacuum using a soft-brush attachment. Fit a new battery. If that doesn't fix it, don't try repairing the unit yourself — the smoke alarm needs replacing.DIY Safe
Recommended partAffiliate linksView partHide

This handbook specifies a 9V battery for the smoke alarm.

9V batteryDuracell Plus 9V Alkaline Batteries (2 Pack) 6LR61~£6.50 for 24.7★ (15,000+ ratings), dispatched/sold by Amazon
View on Amazon →
N/A
CO alarm emits an audible 'chirp' once a minute
A fault with the battery, sensor, or circuitry, including a low battery.Fit a fresh battery straight away for everyone's safety. If it keeps chirping even with new batteries and it's still under warranty, contact technical support for advice; once out of warranty, swap the detector for a new one.DIY Check / Tech Fallback
Recommended partsAffiliate linksView 4 optionsHide

Does the CO alarm itself need replacing? It may be a sealed unit with a built-in battery. FireAngel lists both of these alarms as suitable for caravans and motorhomes:

The handbook doesn't name the battery type, so check your own alarm (and the expiry date on its back) before choosing.

Sealed unit (10-year battery)FireAngel FA3322 Digital Carbon Monoxide Alarm~£37.994.6★ (700+ ratings), sold by FireAngel, dispatched by Amazon - battery sealed in for the alarm's life
View on Amazon →
Replaceable batteries (2x AA)FireAngel FA3313 Carbon Monoxide Alarm~£18.984.7★ (970+ ratings), dispatched/sold by Amazon - supplied with 2x AA batteries
View on Amazon →

Are the batteries replaceable in your CO alarm? Check which type it takes (look at the batteries fitted now), then choose the matching pack:

AA batteriesDuracell Plus AA Alkaline Batteries (12 Pack) 1.5V, LR06~£9.00 for 124.7★ (71,000+ ratings), dispatched/sold by Amazon
View on Amazon →
9V batteryDuracell Plus 9V Alkaline Batteries (2 Pack) 6LR61~£6.50 for 24.7★ (15,000+ ratings), dispatched/sold by Amazon
View on Amazon →
N/A
CO alarm sounds (loud audible signal, alarm LED flashing red once a second)
Carbon monoxide detected in the motorhome.Stay calm and open every door and window for ventilation. Turn off and stop using any appliance that burns fuel. Get everyone out, leaving the motorhome's doors and windows open, and don't go back in until the alarm stops. Anyone showing signs of CO poisoning needs medical attention. Keep the motorhome out of use until your supplying retailer has fully serviced every appliance - a GAS SAFE registered installer must be the one to test the gas appliances.Professional Intervention Required