Truma Electric Fireplace Cover
This electric fireplace cover optically and acoustically simulates a burning fireplace when operated exclusively with compatible Truma space heaters. It features remote-controlled flame simulation, adjustable crackling sounds, and brightness settings operating on a 12V SELV power supply.
View official manual on manufacturer's site ↗Technical Specifications
Power Consumption 12v12 W (quiescent current < 1 mA)
Weight Kgapprox. 2.8 kg
Master Troubleshooting & Diagnostics Matrix
| Error Code / Indicator | Symptom / Meaning | Possible Cause | Step-by-Step DIY Fix | Suggested Actions |
|---|---|---|---|---|
Fireplace does not light up, flame is not visible. | Flame intensity is too low or turned down. | — | Increase the intensity. | DIY Safe |
Crackling sound cannot be heard. | Volume is set too low. | — | Increase the volume. | DIY Safe |
Fireplace does not respond to remote control commands. | Remote control is not properly aligned with the IR receiver. | — | Aim the remote at the IR receiver when you use it. | DIY Safe |
Function selection indicator on the remote control does not respond to button presses. | Battery issue in the remote control. | — | Check that the remote control batteries are in perfect condition! | DIY Safe |
Fireplace does not work. | Power supply, fuse, battery charge, or system lockup issue. | — | Check the power supply and that the plug is properly connected, check the fuse in the vehicle's electrical system or power cable, and make sure the supply battery is healthy and fully charged. Then reset it by cutting the power for at least 20 seconds. | DIY Safe |
Frequently Asked Questions
Q: Which heaters can this fireplace cover be used with?
It is exclusively approved for operation with Truma S 5004 / S 5004 E (NL) heaters.
Q: What batteries are required for the remote control?
Only use leak-proof micro batteries - type LR 3, AM4, AAA, or MN 2400 (1.5V).
Q: How do I perform a manual switch-on or factory reset directly on the cover?
A press of about 1 second on the button under the cover switches the fireplace on with its last-used settings; holding it for about 3 seconds puts it back to its factory settings.