Error LO-BAT: Safe lock doesn't close

Possible cause: Battery is low.. Replace the batteries.

Error E-CODE: Safe emits three short audible signals

Possible cause: False code or false master code entered.. Enter the correct code or master code.

Error HOLD15: Safe emits two short audible signals whenever any button is pressed

Possible cause: Entering the wrong code three times has disabled the safe's lock.. Leave it for 15 minutes without touching any buttons, then enter the correct code - or open the door mechanically using the master key.

← Back to Appliance Troubleshooting

Coachman • Security & Alarms

Covers: Acadia, Laser, Laser Xcel

+1 more

VIP

Acadia models: 460, 520, 545, 565, 575, 630 Xtra, 660 Xtra, 675 Xtra

VIP models: 565, 575

Laser models: 650, 665, 675

Laser Xcel models: 845, 850, 875

Coachman Security & Alarms

(2022 Model Year)

View official manual on manufacturer's site ↗

Reference

Phantom VanGuard alarm remote (two are supplied), from the 2022 Coachman handbook. Each button has its name printed beside it in the handbook's picture.

1 Arm
2 Disarm
3 Pet mode / night mode - arms the alarm without the wireless PIR sensor(s)
4 Awning / dome light

Master Troubleshooting & Diagnostics Matrix

Error Code / Indicator	Symptom / Meaning	Possible Cause	Step-by-Step DIY Fix	Suggested Actions
`LO-BAT`	Safe lock doesn't close	Battery is low.	Replace the batteries.	DIY Safe
`E-CODE`	Safe emits three short audible signals	False code or false master code entered.	Enter the correct code or master code.	DIY Safe
`HOLD15`	Safe emits two short audible signals whenever any button is pressed	Entering the wrong code three times has disabled the safe's lock.	Leave it for 15 minutes without touching any buttons, then enter the correct code - or open the door mechanically using the master key.	DIY Safe

Frequently Asked Questions

Q: How do I arm and disarm the mobile alarm system?

To arm the system, hit the arming button - two quick high-pitched beeps confirm it, and the dome light stays lit for about 30 seconds. It waits 30 seconds before fully arming, giving you time to get clear of the caravan. Disarming it just means pressing Button 2 (Disarm) on the remote - you'll get three beeps this time, with the dome light again staying on for around half a minute.

A low PIR battery shows up as an extra 'bop' after the arming tone (it takes 2 CR2032 cells to replace). If you'd rather leave the wireless PIR sensor(s) switched out, press Button 3 (Pet Mode/Night Mode) on either remote to arm without them instead.